Comments for TOCPCs - The Elite Geeks Blog

Comment on DD-WRT impresses again! by oliverr

oliverr — Sat, 11 Feb 2012 17:29:40 +0000

it has this option but it does not turn off the radio immediately .

Comment on Finally Licensed by criten

criten — Fri, 25 Nov 2011 00:36:11 +0000

Lucky bastard. I did the other route and had mine suspended for demerit points over highly stupid traffic infringements.

Drive safe(er than me)!

Comment on How to: Avoid the Government’s Internet Filter. Easy! by Free Ebooks

Free Ebooks — Fri, 18 Nov 2011 03:57:59 +0000

Hello there, You have done an incredible job. I will certainly digg it and in my view recommend to my friends. I am confident they will be benefited from this web site.

Comment on How to: Avoid the Government’s Internet Filter. Easy! by cambridge satchel

cambridge satchel — Thu, 17 Nov 2011 14:49:52 +0000

I will immediately take hold of your rss feed as I can’t in finding your email subscription link or e-newsletter service. Do you have any? Please permit me realize so that I could subscribe. Thanks.

Comment on Linksys routers with DD-WRT firmware by best nas server

best nas server — Thu, 17 Nov 2011 07:27:34 +0000

I like the helpful info you supply in your articles. I’ll bookmark your blog and check once more here regularly. I am somewhat certain I will learn a lot of new stuff right right here! Best of luck for the following!

Comment on HOWTO: Configure a Linksys SPA-3102 ATA to a VoIP Provider on ADSL by microsoft professional plus 2010 serial

microsoft professional plus 2010 serial — Wed, 16 Nov 2011 16:32:24 +0000

Hi, Neat post. There’s an issue together with your web site in internet explorer, could test this? IE still is the marketplace chief and a big section of other folks will omit your great writing due to this problem.

Comment on HOWTO: Configure a Linksys SPA-3102 ATA to a VoIP Provider on ADSL by office professional plus 2010 keygen

office professional plus 2010 keygen — Wed, 16 Nov 2011 14:54:56 +0000

Normally I do not learn article on blogs, but I wish to say that this write-up very compelled me to check out and do so! Your writing style has been surprised me. Thank you, very nice post.

Comment on Granny Flat Hot Water Pipe by Electrician

Electrician — Wed, 16 Nov 2011 06:40:37 +0000

I’m surprised you didn’t think about one of those ‘Zip’heaters, which heats up the water in an instant before if comes out of the tap – allowing you to have as much hot water as you like.

Comment on Granny Flat Hot Water Pipe by Test 2 | Your Questions About Putting A Washer On A Tap

Test 2 | Your Questions About Putting A Washer On A Tap — Sun, 13 Nov 2011 21:41:47 +0000

[...] you can get a compression fitting at home center to cap off broken line. Powered by Yahoo! Answers Donna asks… outside water pipe broke. But it flooded the inside of the house will insurance cover… the inside of the house will insurance cover the floor in the [...]

Comment on Linksys routers with DD-WRT firmware by url shortener

url shortener — Sat, 29 Oct 2011 05:44:01 +0000

Thanks for every other informative blog. Where else may I am getting that type of info written in such a perfect method? I have a undertaking that I’m simply now working on, and I have been at the look out for such information.

Comment on Creating a limited access network. by criten

criten — Fri, 21 Oct 2011 23:19:57 +0000

Why limit access? Just use TC to cap her at something like 512kbit down and 128kbit up and no more (if you have a lunix box acting as a router).

That way she can’t even max out your Internet by hitting YouTube.

Comment on My First Lawn Mower by criten

criten — Fri, 21 Oct 2011 23:16:50 +0000

Is it 2 stroke or 4?

You can actually mix the oil into regular fuel if its 2 stroke. Almost sounds like the oil mix is too strong as the spark plug continues to dirty.

Comment on A drainage trench by criten

criten — Fri, 21 Oct 2011 23:14:16 +0000

Good work on the drainage trench.

We had similar issues at home some years ago and my grandfather who is a builder flipped right out saying that flowing water near foundations is an issue to resolve immediately as it can cause significant structural damages that’d require demolition of the building.

Comment on HOWTO: Configure a Linksys SPA-3102 ATA to a VoIP Provider on ADSL by Bill

Bill — Wed, 19 Oct 2011 20:56:46 +0000

I have a company supplied Cisco (303) IP phone, the problem I have is that my modem is at other end of the house from my office. I order a WBP54G v2 wireless bridge adapter for phone and a SPA 3102 VOip router. I am unsure of the settings in the router to make them communicate with each other. I have gone through the bridge adapter setup via the cd that came with it and when it comes to making connection, I can not get the software to refresh through CPU. Does anyone out there have any help??

Comment on Loading Custom Characters into HD44780 LCD display by BELKIN LCD Display Cleaner F8E404 | New HDTV Store

BELKIN LCD Display Cleaner F8E404 | New HDTV Store — Thu, 06 Oct 2011 21:32:36 +0000

[...] dust particles Belkin LCD Cleaning System F8E404 Cleaning Kits List Price: $ 9.99 Price: $ 3.99 BELKIN LCD Display Cleaner F8E404 Ideal cleaning solution for LCD flat-screen monitors and notebooks…3> Ideal cleaning solution for LCD flat-screen monitors and notebooksIncludes a micro fiber brush [...]

Comment on Yum Install CentOS-5 (Upgrade from CentOS 4.4 to CentOS 5) by wow

wow — Thu, 06 Oct 2011 20:10:24 +0000

Wow. Not trolling, but can’t believe this is what it takes in RH/CentOS!

If you have never tried Debian, I highly recommend it. upgrading between versions is simply updating your sources to point to the new version (takes a few seconds, just a few lines, in a single file, with a single word on each needing to be changed). Then, “apt-get update && apt-get dist-upgrade” Done. Been doing this since early 90′s, never had to re-install a box.

Forced to use RH/CentOS for 3rd party support for one box at work– which brought me here.

Again, wow!

Comment on Floorboards – Better than carpet by Insulated Floor Boards - How to Choose the Right One? | Insulated Plasterboard

Tue, 20 Sep 2011 07:12:40 +0000

[...] boards systems. Remember, you can save a lot of money if you install the right floor insulation.Insulated floor boards provide great savings for homeowners. A typical household without floor insul…Fortunately, it is very easy to insulate the floor boards. As long as you have the right materials [...]

Comment on What colour is the Australian $20 note? by Caroll

Caroll — Tue, 06 Sep 2011 12:22:16 +0000

My sisster inlaw and I have diffrent opions I think its orange and she thinks its red but we put it on our facebook pages and we got about fiffty fiffty results But i still think i’m right lol

Comment on Setting up ChilliSpot with FreeRadius on Tomato by winyl

winyl — Fri, 02 Sep 2011 14:38:45 +0000

I can tell you it is possible to run freeradius and postgre/mysql on the router itself. I have set it up on my rt-n16 with optware. Well maybe it wont achive blazing speeds but it works with 2 hdd attached no problem.

Comment on How to: Avoid the Government’s Internet Filter. Easy! by All you need to know that the Australian Governments Censorship Plan is Bollocks (and more) « Adelaide Blue Haggis Bistro

Wed, 17 Aug 2011 09:21:57 +0000

[...] to evade the filter using any of many easy methods. (Dead link as of [...]

Comment on HOWTO: Log a kernel panic.. It can be done! by RAIN, RAIN, BEAUTIFUL RAIN! « The Blog of Wildstar, aka Jimpossible

RAIN, RAIN, BEAUTIFUL RAIN! « The Blog of Wildstar, aka Jimpossible — Wed, 17 Aug 2011 04:59:07 +0000

[...] HOWTO: Log a kernel panic.. It can be done! – from http://www.tocpcs.com/"The Elite Geeks’ Blog me:This looks like a great blog for you fellow geeks out there, so check it out! [...]

Comment on Loading Custom Characters into HD44780 LCD display by Loading Custom Characters into HD44780 LCD display | TOCPCs – The … | Electronics Blog

Tue, 16 Aug 2011 18:55:01 +0000

[...] characters in addition to the standard character set … Read more from the original source: Loading Custom Characters into HD44780 LCD display | TOCPCs – The … This entry was posted in Uncategorized and tagged been-trying, character-set, custom-characters, [...]

Comment on HOWTO: Configure a Linksys SPA-3102 ATA to a VoIP Provider on ADSL by Netbone China

Netbone China — Mon, 15 Aug 2011 19:00:04 +0000

Excellent weblog right here! Also your website lots up very fast! What web host are you using? Can I get your affiliate hyperlink to your host? I desire my web site loaded up as fast as yours lol

Comment on A flat battery already! by criten

criten — Thu, 11 Aug 2011 06:26:30 +0000

Wreckers will pay you about $200 for your Sonata. So its just a game of trying to get more than that…

Comment on Free Credit Card Number Validation: Server Side by Robert

Robert — Tue, 09 Aug 2011 05:46:55 +0000

Can u send a valid credit card details to me please
Send it to my email.

Comment on New Job, New Car by The Elite Geek

The Elite Geek — Mon, 08 Aug 2011 09:03:05 +0000

He must be a tad more senile than I previously thought…

Comment on New Job, New Car by criten

criten — Tue, 02 Aug 2011 01:15:09 +0000

New job eh? Congrats – hope it keeps you more interested. JL said you’re at Newcastle Uni now?

Comment on Our new car by OzCableguy

OzCableguy — Wed, 20 Jul 2011 03:31:51 +0000

I miss our Pulsar. When we bought it I actually started losing interest in my old Monaro. It was just so zippy and quiet.
We’ve just inherited an old Mazda 323 and while it’s fun to drive and there’s a throaty growl under the bonnet when you put the foot down, it’s just not quite as groovy to drive as the Pulsar.

Comment on HOWTO: Configure a Linksys SPA-3102 ATA to a VoIP Provider on ADSL by Rangam

Rangam — Mon, 18 Jul 2011 23:34:58 +0000

I was using SPA 3120 for making my PSTN calls thrugh VOIP and it was working ( aussie broadband). Now I have changed ISP to TPG and unable to register though I used all the settings as suggested. TPG does not help to configure. It worked once but failed then. I then applied factory configuration to SPA 3102 and re configured. but not registering. not sure about the dial plan also.

any advice.

Comment on HOWTO: Log a kernel panic.. It can be done! by Joe Turner

Joe Turner — Mon, 18 Jul 2011 21:04:55 +0000

Thanks for these instructions, but your examples could be better. You switch from a totally bogus IP address in one section (“123.456.789.012″) to specific 192.168.0.x addresses, and you don’t specify which is the “bad” machine and which is the “logging” machine in the modprobe example.